|
View previous topic :: View next topic
|
| Author |
Message |
desgnr
Joined: 07 Mar 2009
Posts: 2
|
 Posted: Sat Mar 07, 2009 3:57 pm Post subject: Need a detail |
    |
|
Where can i get a detail of an LVL beam to use after removing a bearing wall?
The 2nd floor joists run parallel to the beam.
I tried Google & could'nt fin any.
I need this detail to get a permit. |
|
| Back to top |
|
 |
nanrehvasconez
Joined: 25 Feb 2008
Posts: 329
|
| Posted: Sat Mar 07, 2009 5:24 pm Post subject: |
|
|
| HAVE A STRUCTURAL ENGINEER SPECIFY THE ADEQUATE BEAM, IN THE LONG RUN IT WILL BE CHEAPER |
|
| Back to top |
|
|
desgnr
Joined: 07 Mar 2009
Posts: 2
|
| Posted: Sun Mar 08, 2009 7:57 am Post subject: |
|
|
I know the size I beam i need.
I just need a sample detail drawing to see how it is drawn. |
|
| Back to top |
|
|
csintexas
millennium club
Joined: 06 Feb 2006
Posts: 2166
Location: USA
|
| Posted: Sun Mar 08, 2009 8:47 am Post subject: |
|
|
Well I can't tell what you need. There are many details available look at the beam manufactures, engineered lumber assoc., websites, books, etc..
In general all they want is a simple detailed drawing of what you plan to build.
_________________
-Chris Stewart
http://bcshdb.blogspot.com >
The B/CS Home Design Blog |
|
| Back to top |
|
|
hungryarchitect
Joined: 07 Feb 2009
Posts: 22
Location: Edmonds, WA
|
| Posted: Sun Mar 08, 2009 9:04 am Post subject: |
|
|
It's a pretty simple detail - just draw it the way you'd build it. Since it replaces a bearing wall and supports a wall above it is either under the rim joist above or it replaces the rim joist.
If you're here on the West Coast or somewhere else where wind or earthquake design are significant elements of the design then you'll definitely want to hire a structural engineer to determine the best connection method between the floor diaphragm above and the beam. Otherwise the prescriptive nailing specified in the code should be sufficient. In any case, just draw it the way you'd build it.
_________________
Rick Anderson AIA
www.hungryarchitect.com/blog |
|
| Back to top |
|
|
Checkpoint43
Joined: 22 Mar 2007
Posts: 180
Location: Lexington, VA
|
| Posted: Sun Mar 08, 2009 10:07 pm Post subject: |
|
|
I would have to agree with nanrehvasconez.
Go with a structural engineer. Permit drawings may require an engineer's seal.
you could also check to see if the LVL and engineered wood product sales company would provide you with the detail drawings you need, including engineering seals.
Good luck with your project. |
|
| Back to top |
|
|
|
blogger
del.icio.us
digg
slashdot
